--The contractor should call
(843)676-8600, at specified intervals, for required inspections.
--Requested inspections will be conducted within 48 hours of the
request.
--The Building Inspection Division has a fax machine available
for the convenience of forwarding permit applications. The fax
number is (843) 676-8613.
Required Inspections
The Building Official, upon the request of the permit holder or
their authorized agent, will make the following inspections and
will notify the permit holder or their authorized agent of any
code violations which must be corrected prior to starting the
next phase of construction.
BUILDING
--Foundation inspection: To be made
after trenches are excavated and forms erected.
--Pier and curtain wall.
--Floor slab and floor framing.
--Exterior wall before covering.
--Wall tie inspection if brick veneer.
--Frame inspection: To be made
after the roof, all framing, fireblocking and bracing is in
place, all concealing wiring, all pipes, chimneys, ducts and
vents are complete.
--Final inspection: To be made
after the building is completed and ready for occupancy.
ELECTRICAL
--Underground inspection: To be
made after trenches or ditches are excavated, conduit or cable
installed, and before any backfill is put in place.
--Rough-In inspection: To be made
after the roof, framing, fireblocking and bracing is in place
and prior to the installation of wall or ceiling membranes.
--Final inspection: To be made
after the building is complete, all required electrical fixtures
are in place and properly connected or protected, and the
structure is ready for occupancy.
PLUMBING
--Underground inspection: To be
made after trenches or ditches are excavated, piping installed,
and before any backfill is put in place.
--Rough-In inspection: To be made
after the roof, framing, fireblocking and bracing is in place
and all soil, waste and vent piping is complete, and prior to
this installation of wall or ceiling membranes.
--Final inspection: To be made
after the building is complete, all plumbing fixtures are in
place and properly connected, and the structure is ready for
occupancy.
NOTE: See
Section P312 of the Standard Plumbing Code for required tests.
|
